How to Projects: Install Molding

View Products by Application

Print this page
Email this page

Project Time: Approximately 2 hours

Complexity:

Gather your materials. You will need: GE Silicone II XST, a tape measure, miter saw, drill, drill bits, coping saw, nail set, utility knife, putty knife, flat bar and sandpaper.
Cut the piece of molding to fit the space.
Using a miter box, make miter cuts for molding that is going to meet at interior or exterior corners.
Using GE Silicone II XST, attach the molding to the wood paneling or wallboard surface.
Nail the molding to the substrate in a few evenly spaced areas, using small finishing nails.
To finish, paint or stain the molding once the adhesive has fully cured.