Big Gaps & Cracks
12 oz
- Expands & seals gaps greater than 1 inch
- Creates an airtight & water-resistant seal
- Helps save energy by reducing drafts
- High R-5 insulating value
- Lifetime guarantee†
†See Product Disclaimers page for important details
Fill gaps and cracks larger than 1 inch with GE-branded Large Gaps insulating foam, offering a water-resistant and airtight seal to keep out water and reduce drafts.
- Wear safety goggles, gloves, respiratory protection, and protective clothing. Protect surrounding areas with drop cloths.
- Shake can vigorously for one minute.
- Screw straw dispenser trigger completely onto can valve. Use caution to avoid activating the valve.
- To become familiar with product, test on experimental surface. Invert can and slowly depress the trigger to dispense the foam. Continue use in an inverted orientation.
- Fill rough openings approximately 1/3 full to allow for expansion. Release trigger 5 seconds before the end point, but keep straw end moving.
- For deep section application, allow the first layer of foam to cure before applying a second layer. Do not disturb uncured foam. See typical product information on label for times.
- Trim cured foam with a sharp knife or sand as needed. Foam exposed to sunlight must be painted or stained.
disclosures -needs logic
For products produced by Henkel Corporation, please use the UPC Code. You can click on the corresponding UPC code below to access the SDS..
| Color | UPC Code |
|---|---|
| White | 28756957362 |
